In Western Mass during this era when knob and tube was in common use, a typical home would have 30 or 60 amp electrical service, sufficient for general lighting and maybe a radio. In those days people were still using  “iceboxes”, wood or gas stoves, coal heat, and no air conditioning. Professional wiring by electricians in  homes was a new trade and there were very few rules.

American Electricians Handbook was the first home wiring guide to electrical rules which appeared around the turn of the century, when Terrell Croft wrote the  Crofts books defining early wiring practices. One of Croft’s rules was that knob and tube wiring should always be run through, never over the house framing. The problem with running wiring over framing is that it can get bumped, snagged, and damaged.

The advantage of knob and tube wiring is that it dissipates heat into free air, and therefore has a higher ampacity than cable systems with equivalent wire size. When originally installed in the 1900′s knob and tube wiring was less expensive than other wiring methods. Due to the installation cost, owners and electricians would opt for knob and tube versus conduit wiring and metal junction boxes. The conduit methods were known to be of better quality, but their cost was significantly higher than knob and tube wiring.

Modern wiring methods assume two or more load carrying conductors will lie against each other, for instance the standard non-metallic – 2 cable. Since the load carrying wires are in close proximity, when they heat up, the heating is shared across the wires, limiting the overall current load they can support. Since the load carrying wires in knob and tube wiring are widely spaced, the wires are capable of carrying higher loads without risk of fire.

Knob and tube wiring was usually insulated with cotton cloth and soft rubberand porcelain insulators. Although the actual wire covering may have degraded over the decades, the porcelain insulators have a very long lifespan and will keep any bare wires safely insulated. These same porcelain insulators were used with bare wire electric fencing for livestock. These insulators can carry very high voltage surges without the risk of shorting to ground. Many electricians understand that by running the hot and neutral conductors farther apart from each other than today’s electrical cabling does make shorts between those conductors less likely, at the same time realizing there is not a grounding conductor.

Knob and tube is insufficient for current usage patterns. Contemporary households use a wide range and intensity of electrical equipment that was unforeseen at the time of knob and tube inception. Household power use increased following World War II, first generation wiring systems became susceptible to abuse by homeowners, who would avoid repeated blown fuses by over fusing the circuits, thus subjecting the wiring to heat damage due to higher levels of current.

In many instances deterioration and abuse have rendered the wiring unsafe. During building renovations and remodeling wiring can become damaged. The rubber insulation will become dried out, brittle when handled, damage by rodent, or simple carelessness…

If you live in Western Massachusetts and you’re concerned about the Knob and Tube wiring in your home, give us a call for an in home inspection and estimate.

Ron Desellier Electric   (413) 478-6192

_________________________________________

Technorati Tags: american electricians handbook, amp electrical service, ampacity, cable systems, ceramic knobs, close proximity, coal, Drywall, electrical conductors, electricians, gas stoves, general lighting, green remodeling, home wiring, junction boxes, kitchen remodeling, knob and tube, knob and tube wiring, residential, Springfield, terrell croft, turn of the century, Western Mass, western mass knob and tube, western massachusetts, wiring practices

Stonebrook Drywall (413) 657-9626

Since 1980 The Stonebrook Group has been providing quality sheetrock services to customers in Western Massachusetts. We offer clean, quick and reliable service as well as true attention to detail.

In Addition to our drywall service we work in conjunction with other contractors in the area to ensure a smooth and trouble free experience for our homeowners.

Other services provided by The Stonebrook Group include:

• First and/or Second coat priming
• Window and Door Installation
  
• Finish Painting
• Woodwork Installation
• Staining and finishing
• Most flooring installations
• Handyman Service

And Much More… If we can’t handle it we know someone who can!

No matter how big or how small you can rest assured that Stonebrook Drywall can handle your sheetrock needs.

We are fully Licensed and Insured and will be glad to provide references upon request

“It is our goal to be your contractor for life”

Give Us a call today for a free consultation

The Stonebrook Group@

phone- (413) 657-9626

e-mail- brian@thestonebrookgroup.com

Technorati Tags: Amherst, Drywall, Hadley, hampden, Holyoke, monson, northampton, plaster, sheetrock, south hadley, wilbraham